Work orders and service reports with signatures

Pro Pro is active in this browser. Open your Pro accountPro free trial is active. Open your Pro accountPro is active but will not renew. Open your Pro account

HVAC Maintenance Checklist

Work through a seasonal HVAC maintenance visit, residential or commercial. Set each check to OK, Fault or N/A, add readings and photos, collect the signatures and download the PDF.

Example: HVAC Maintenance Checklist with the default input (Number: HMC-0001, Date: 2026-01-15, Property type: Residential, Visit: Spring or cooling season, Equipment type: Furnace). The live tool loads here.

Your business

Your logo

Printed at the top of the PDF. Stays in this browser. Pro also removes the footer line.

Customer and job site

Job details

Maintenance checklist

Residential: cooling season

Air filter checked, replaced if dirty
Outdoor coil clear of leaves, grass and debris
Evaporator coil inspected
Condensate drain line and pan clear
Refrigerant line insulation intact
Thermostat set and tested
Supply and return air temperatures recorded

Residential: heating season

Burners and heat exchanger visually inspected
Flue and vent connections secure
Ignition and flame checked
Blower motor and wheel clean
Carbon monoxide alarm tested
Boiler pressure, expansion tank and leaks checked

Commercial: rooftop and packaged units

Belts checked for wear and tension
Bearings and motors lubricated as the maker requires
Economizer dampers move freely
Coils cleaned
Condensate pans and drains clear
Fan motor amps compared with the nameplate
Contactors and capacitors checked
Panels and curb seals closed and sealed

Commercial: controls and records

Setpoints and schedules checked
Filters changed to the site schedule
Refrigerant leak checks and service records updated
Exhaust and make-up air fans run
Alarms and safety cut-outs tested

Parts, materials and labour

Photos

Take a photo or pick from your gallery. Photos are shrunk on your device and go into the PDF; they are not uploaded. Up to 12.

Signatures

Sign inside the box with a finger, pen or mouse.

My reports

Nothing saved yet. Reports you download or save appear here, in this browser only.

nullnullnull

This month

Free · runs in your browser · nothing is uploaded

Open on Signvisit

This embed was switched off for this website. Open on Signvisit

Add this tool to your siteFree embed code, no sign-up. Keep the credit link.

Embed this tool

Copy this code into your website, blog or class page. The tool runs inside your page.

Optional settings, added to the address after embed=1: &accent=0f6b5c (colour, 3 or 6 hex digits). Other parameters are ignored.

Please keep the credit link below the tool.

An HVAC maintenance checklist is the list of checks a technician makes on a heating, cooling or ventilation system during a planned visit, with the result of each one. It is different from a service report: a report records what was wrong and what was done, while a maintenance checklist records that each routine check was made, so the next visit starts from the last one.

This page has four groups of checks. Two are for homes (cooling season and heating season) and two for commercial buildings (rooftop and packaged units, and controls and records). Use the groups that fit the visit and set the rest to N/A. Add the equipment details, readings and photos, get the signatures and download the PDF.

At a glance

An HVAC maintenance checklist lists the checks made on a heating, cooling or ventilation system at a service visit, with the result of each check and the sign-off.

  • The checklist has four groups: residential cooling, residential heating, commercial rooftop and packaged units, and commercial controls and records.
  • Each check is set to OK, Fault or N/A, and the PDF lists the result next to it.
  • Up to 12 photos with captions and two signatures go into the PDF; nothing is uploaded.
  • Releasing refrigerant on purpose while servicing air conditioning equipment is prohibited under Section 608 of the US Clean Air Act.

Sources: US EPA, Stationary refrigeration and air conditioning (Section 608) (checked 2026-11-13)

How to fill in the HVAC maintenance checklist

  1. Enter your business name and contact. Tick the box to keep them on this device.
  2. Check the number and date, then enter the technician and the customer or site.
  3. Pick the property type, the kind of visit and the equipment type. Copy the make, model and serial number from the data plate and note the filter size.
  4. Go through the check groups. Set each check to OK, Fault or N/A. Skip a whole group by leaving it as N/A, for example the commercial groups on a home visit.
  5. Write the readings in the readings box: supply and return air temperatures, pressures and motor amps that you measured, with units.
  6. Write recommendations, for example a belt or capacitor that is wearing and should be replaced at the next visit.
  7. Photograph the data plate, any fault and the finished work, and add a short caption to each photo.
  8. Sign, get the customer’s signature and download the PDF. Send it to the customer or keep it with the site record so the next visit starts from this one. For a second unit at the same address, change the equipment fields and download a separate PDF.

What is included in an HVAC maintenance checklist?

The details of the equipment, the checks and their results, readings, recommendations and the sign-off. For cooling that means the filter, the outdoor and indoor coils, the condensate drain, the refrigerant line insulation, the thermostat and the air temperatures. For heating it means the burners and heat exchanger, the flue and vent connections, ignition and flame, the blower and a carbon monoxide alarm test. Commercial units add belts, bearings, dampers, motors, contactors, setpoints and records.

Residential and commercial: what changes?

A home visit is short and covers one or two systems. A commercial visit covers more units, more moving parts and a site record: filter schedules, setpoints and leak-check records. The groups here are split that way so that one page serves both. Pick the groups that fit and leave the others at N/A; the PDF lists the result of every check, so the customer sees what was and was not covered.

How often should HVAC maintenance be done?

Many service providers visit twice a year, before the cooling season and before the heating season, and commercial sites often add quarterly visits for filters and belts. The right interval depends on the equipment, the site and the maker’s instructions, so follow those. The Visit field on this form records which kind of visit it was.

What readings should I write down?

Whatever you measured, with its unit: supply and return air temperature, refrigerant pressures where you are certified to take them, gas or boiler pressure, and motor amps against the nameplate. A reading on its own says little, but the same reading at the next visit shows a trend, such as a coil that is slowly clogging or a motor drawing more each season.

What do the rules say about refrigerant?

Section 608 of the US Clean Air Act prohibits intentionally venting ozone-depleting refrigerants and their substitutes, such as HFCs, while maintaining, servicing or disposing of air conditioning or refrigeration equipment (US EPA). The checklist only records that a leak check was made. Refrigerant work itself needs a certified technician and your own records. Check the rules that apply to you.

No. It is a record of the checks you ticked. Follow the equipment maker’s instructions and any local rule for the unit in front of you.

Frequently asked questions

What is included in an HVAC maintenance checklist?

Equipment details, routine checks with a result for each, readings, recommendations and signatures. Cooling, heating and commercial units each have their own group of checks.

Can I use it for both homes and commercial buildings?

Yes. Use the residential or the commercial groups and set the others to N/A.

Do the photos and signatures go into the PDF?

Yes. Up to 12 photos with captions and the technician’s and customer’s signatures are printed in the PDF. Nothing is uploaded; the PDF is built on your device.

Does it replace the service report?

No. Use the HVAC service report template when you also need to record a fault, work done and parts.

How often should I do a maintenance visit?

Many providers visit before the cooling season and before the heating season, with extra visits at commercial sites. Follow the maker’s instructions for your unit.

Do I need an account or an app?

No. The form runs in your browser, your business details stay on this device if you choose, and the PDF is made locally.

Can I add my own checks?

Not on this page. Use the N/A setting for checks that do not apply and write extra items in the readings or recommendations box.